Proto-x SLT Manuel d'utilisateur télécharger pdf (Page 6)

360° AERIAL FLIPS (Expert Mode Only)

Tip: Perform the flip while gaining altitude.

Quickly push the stick halfway one direction and then quickly push to the

opposite direction.

TROUBLESHOOTING

PROBLEM: The quadcopter will not respond to the controller.

SOLUTION:

(1) Charge or change the battery on the quadcopter (2) Make

sure that the throttle is at 0% and the throttle trim at or below center. (3) Turn

off the quadcopter for a minute and turn it back on. (4) Relink the controller and

quadcopter – See Linking the Quadcopter and Controller instructions on page 7.

PROBLEM: Red controller LED light flashing after binding.

SOLUTION: Replace with new AAA batteries.

PROBLEM: Gyro not working properly.

SOLUTION: (1) Battery voltage low. (2) Re-bind. (3) Land on to the ground

for 3 seconds and take off again.

PROBLEM: Unable to Flip.

SOLUTION: (1) Not enough power. (2) Press the elevator/aileron (right)

joystick one time to enter the expert (flip) mode.

PROBLEM: Quadcopter is shaking.

SOLUTION:

Check the canopy, chassis, motors and rotor blades for damage.

PROBLEM: Will not take off.

SOLUTION: Rotor blades incorrectly installed.

Check that the rotor blades are properly installed:

PROBLEM: Quadcopter is always drifting to one direction.

SOLUTION: Calibrate the sensors.

1. Turn on the controller and the quadcopter.

Place the quadcopter on a flat surface.

2. Hold the left stick to the lower right. At the

same time, quickly move the right stick left

and right several times until the blue LEDs

flash.

Test the model to see if it will hover without drifting. If the model is still drifting, try

putting a thin piece of cardboard under the motor or motors in the same direction

that the quadcopter is drifting. Perform the sensor calibration procedure again.

B = B A = A

B = B

A = A

1 2 3 4 5 6 7 8

Pas de commentaire

Proto-x SLT Manuel d'utilisateur Page 6